We'll need:
A 10-mm wrench.
Warm water
Liquid soap
Brush
Scrub Brush
Sponge
Thorough cleaning and drying will ensure that the melanger operates effectively.
Remove the finished product. Detach the bowl, the clamping screw, and
the millstone holder, as shown below.
Place the red unit with the motor away from the water. If it is dirty, use a damp cloth.
Use warm water and a brush to remove any remaining chocolate or nut butter.
Next, remove the millstones from the holder using a wrench. This is necessary to clean the axles and the holes in the millstones.
Over time, the buildup of residue in these areas can cause various problems. That is why it is so important to clean the shafts and holes in the melanger’s grinding discs.
Do not use the dishwasher.
Use a brush to remove any residue from the holes in the millstones.
Then, before drying, rinse everything with clean, warm water.
The bowl, grinding discs, and holder can be dried using a stream of dry air.
All parts of the melanger must be completely dry before assembly.
Use a heat gun or hair dryer to speed up the drying process. It’s important never to direct heat at one spot for too long. Use smooth, wave-like motions across the surface to avoid damage.
Make sure the holes in the grinding stones are dry, as moisture tends to remain inside, causing product residue to build up.
Once all the parts are dry, you can assemble them as shown below.