Launching the Melanger for the first time. What to look out for

    A melanger is a piece of equipment used in food production. Before using it to prepare your unique product, you must thoroughly clean it after assembly and transport.

     

    Special attention should be paid to the inner walls of the container, the stone millstones, and the bottom, as well as to all components and joints that will come into contact with the product during the grinding process.

     

    When you start the melanger for the first time, let it run for a while with vegetable oil.

     

    This cleaning step involves running the melanger with oil inside the bowl. It is recommended to use oil instead of water for two reasons: water cannot completely remove stone dust from the grinding stones, whereas oil penetrates every nook and cranny of the melanger. In addition, the oil lubricates the slide bushings in the grinding stones, extending their service life by reducing friction.

     

    Any vegetable oil, such as sunflower oil, corn oil, peanut oil, shea butter, or cocoa butter, can be used. After rinsing, keep in mind that a small amount of oil may remain in the stones and fittings; therefore, it is recommended to use deodorized oil or the type of oil that will be used in the final product.

     

    To achieve optimal cleaning during the first run, it is recommended to let the melanger run for 15–30 minutes. If desired, you can perform several additional rinses for a more thorough cleaning. It is recommended not to press the millstones too hard against the bottom of the bowl; the upper clamping screw should be loosened, just as during the conching process. The scrapers should be left in place, as they help ensure proper mixing of the oil inside the melanger, improving the quality of the cleaning.

     

    How much oil should I add?

     

    You must add enough oil to lubricate the millstone bushings—that is, above the axes on which the millstones rotate. Ideally, this should be half the maximum capacity of the bowl. For the Premier Wonder model, this is 0.75 liters; for the Lifestyle model, it is 1 liter. However, if the bushings are sufficiently lubricated while the bowl is rotating even when it is not completely filled, this is also acceptable.

     

    The key requirement is that the bushings must be well-lubricated.

     

    It is believed that for the melanger to work properly, the millstones need to be run in.

     

    To some extent, yes. The new stone base of the bowl and the millstones may have imperfections that will disappear over time, ensuring better contact.

     

    There is no need to specifically run the melanger idle to break it in. And under no circumstances should you run it without oil in the bowl! It is sufficient to run a few “wash” cycles to prepare the melanger for operation. Further breaking in will occur automatically during the production process.

     

    Melanger Premier


    0